Human DRD4 Genotyping

Explore the basics of human DRD4 genotyping and learn how to analyze a variable number of tandem repeats (VNTR) in the dopamine receptor D4 gene.

This step-by-step protocol guides you through collecting cheek cell samples, preparing DNA for PCR, and amplifying the DRD4 gene region using specific primers. You'll also learn how to prepare an agarose gel, perform gel electrophoresis, and compare your PCR results against a DNA ladder to estimate the number of repeats based on fragment length.

The guide introduces the genetic background of DRD4 and explains how differences in repeat numbers have been studied in relation to dopamine signaling and various behavioral traits.

What Is PCR?

The polymerase chain reaction (PCR) is a laboratory method widely used to amplify copies of specific DNA sequences rapidly, to enable detailed study. 

PCR was invented in 1983 by American biochemist Kary Mullis at Cetus Corporation. Mullis and biochemist Michael Smith, who had developed other essential ways of manipulating DNA, were jointly awarded the Nobel Prize in Chemistry in 1993.

Read More

About DRD4 Genotyping

Another gene encoding dopamine receptors is DRD4, which is highly expressed in the prefrontal cortex and other brain regions that are involved in the reward circuits that mediate the reinforcing properties of food, such as the hippocampus, amygdala and hypothalamus [38], [39]. The most widely studied polymorphism of the DRD4 gene is located in the third exon and contains a 48 base-pair, variable number of tandem repeats (48-bp VNTR). Nine alleles of the DRD4 48-bp VNTR have been identified worldwide, with the number of repeats ranging between 2 and 10. The 4- and 7-repeat (7R and 4R) alleles are the most common globally [40]. The number of 48-bp repeats has been hypothesized to affect the transmitted signal in the postsynaptic neuron. Individuals with at least one allele containing seven or more repeats show both reduced binding affinities and receptor densities for dopamine neurotransmission [41].


The DRD4 gene has been associated with addictive behaviours [42] and with increased food intake in patients treated with D4 receptor-related antipsychotics [43]. The 7R allele has been linked to attention deficit and hyperactivity disorder (ADHD) [44]–[46] and to body weight gain in patients with seasonal affective disorder [47]. The 7R allele has also been found to be associated with impulsivity and lower levels of response inhibition in healthy adults, both alone and in combination with other polymorphisms in dopamine system genes, such as DRD2 [48], [49].

Research into the link between DRD4 and cognitive functions has also yielded mixed results. Some studies have reported associations between being a carrier of 7R allele and impairment on executive function tasks in healthy children [50], as well as in children with ADHD [50]–[52]. However, Manor et al. [53] reported just the opposite: their ADHD children with the DRD4 long repeats (6–8) performed better on attention than did those bearing the DRD4 short repeats (2–5). In a recent study of healthy adults, 7R allele carriers showed impaired reaction times compared with non-carriers [54]. In addition, a recent experimental study demonstrated impaired attentional performance in animals with a genetically-induced reduction in DRD4 expression [55]. Other studies, however, have shown no differences in performance on different attentional domains for 7R carriers among ADHD patients [44], [51], [53].

The Primers Used Are:

DRD4 Fwd:

GCGACTACGTGGTCTACTCG

DRD4 Rev:

AGGACCCTCATGGCCTTG

A PCR run with these primers will amplify the DRD4 VNTR.

PCR product length and number of repeats is calculate by taking 283bp and adding 48 per repeat.

Number of Repeats and Expected Length:

2:

379bp

3:

427

4:

475

5:

523

6:

571

7:

619

8:

667

9:

715

10:

763

Step: 1

General PCR Protocol

Rinse your mouth with water and then rub inside of cheek with tip 
of cotton swab.

Take cheek swab and place in 300uL 50mM NaOH in microcentrifuge tube.

Stir swab in tube for 1 minute until solution is cloudy.

Heat tube in almost boiling water for 10 minutes (95°C).

Add 300uL of 50mM Tris.

For a 50uL PCR reaction.

10uL of cheek cell solution for PCR reaction template.

1uL of each DRD4 primer or 1uL of DRD4 primer mix.

10uL of 5x Master Mix(or 25uL of 2x Master Mix).

28uL water with 5x Master Mix(or 13uL with 2x Master Mix).

Use the PCR Protocol Below:

1.

95°C for 10 Minutes.

2.

95°C for 15 seconds.

3.

55°C for 1 minute.

4.

72°C for 1 minutes. 

5.

Loop to step 2 39 times.

6.

72°C 10 minutes.

Step: 2

Prepare for Gel Electrophoresis 

Make TAE buffer if you don’t have it by adding 5g of TAE mix to 
1L of distilled water.

Add 0.5g of agarose to 50mL of TAE buffer (DON’T USE WATER!) 
and microwave it on high for 1 minute or until all agarose is dissolved. 
The solution should become clear.

Let the molten gel cool until it can be handled. While it’s still very warm 
add 5uL of DNA Dye to the still very warm molten agarose solution and 
swirl around to mix.

Pour the molten agarose into your gel mold and let it set. This usually takes around 20-30 minutes but can be sped up by placing it in the fridge.

Add 4-5uL of 100bp DNA ladder to the first or last lane of the gel.

Add 9uL of DNA loading buffer to your PCR reaction and then add 20uL to the gel.

Step: 3

Results

Compare the samples to the DNA ladder using your yellow/orange film and blue light. Put the film in front of your eyes and shine the blue light on the gel. The bands in the gel should fluoresce. Individuals with genes around 300-400bp have a wild type gene (normal human gene) and those who have 600+bp have a version of DRD4 that is associated with risk taking behaviour!  

Below is an example of an agarose gel with the 100bp DNA ladder in the first lane and the PCR product in the second lane. The PCR band is ~300-400bp indicating the person has the wildtype gene.

Ready to Run Your PCR?

Explore the tools and supplies you need to take your genetic experiments further, from PCR amplification to DNA analysis.

Complete Genetic Engineering Lab Kit

Complete Genetic Engineering Lab Kit

$1,664.00 USD